This energy is stored internally in a high capacity Li-Ion
cell where it can be retrieved at any time. This enables the
lights to stay on after stopping. Additionally a phone or
similar USB device can be charged simultaniously with a
maximum current of 2.4A
Indicators for charging, light outputs, USB outputs and others
are combined with a simple button interface to turn them on and off.
An active rectifier ensures maximum efficiency while loading the
dynamo in its optimal working point via maximum power point
tracking (MPPT). Front and back lights can be modulated from
0% to 100%. The USB output is disabled if battery is low to
ensure maximum safety and visibility.
Specs:
- 5.5-20Vpp input voltage
- 0-100kHz input frequency
- AC and DC input
- 1A maximum charging current
- Separate front and back light dimming
- Bluetooth BLE connectivity
- 2.4A USB-C output
The connectors are rated for IP67/68 and very well suited for
the rough conditions the dynline gets exposed to. Waterproofed
case with o-ring gaskets and water lips. The USB output is IP67
rated and additionally has a seal to prevent water ingress.
Buttons are molded out of silicone and withstand continuous pressing,
water ingress is avoided by a tight seal and large overhang on the
inside.
When stopping at traffic lights, stop signs, crosswalks and others,
normal lights immediately cease lighting. The dynline can continue
delivering 6V for the front and back while being stopped. This
is a savety feature and makes driving at night a lot saver.
If needed it will dimm down the lights to save battery and
switch to a blinking mode for greater contrast.
